Heat-controller DMC24DB-1 Manuel d'utilisateur télécharger pdf (Page 13)

Operating Instructions

Owner's Manual 13

Cooling

Healthy

Dehumidification

Auto

Heating

(Heat pump model only)

To lower the temperature

To raise the temperature

(Cooling Only

model)

(Heat Pump

model)

Press the Start/Stop button.

The unit will respond with beep

sound.

Open the door on the Remote Controller. To select Auto

Operation, press the Operation Mode Selection button.

Each time the button is pressed, the operation mode is

shifted in the direction of the arrow.

The temperature and fan speed are automatically set by the

electronic controls based on the actual room temperature. If

you want to change the set temperature, press the Room

Temperature Setting buttons. The set temperature will be

changed considering room temperature.

DURING AUTO OPERATION:

❏ You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.

❏ If the system is not operating as desired, manually switch to another mode. The system will not

automatically switch from the cooling mode to the heating mode, or from heating to cooling, then you must

set the mode and the desired temperature again.

❏ During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and down

automatically. If you want to stop auto-swing, press the chaos swing button again.

Auto Operation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Pas de commentaire

Heat-controller DMC24DB-1 Manuel d'utilisateur Page 13